How do I mark the position of the pin on CONNEX?

Marking the position of the pin on a hole can be done in three ways

Option one: once you have holed out, press the ‘PinCollect’ button over the hole. This will mark the position of the pin in your current position and move you on to the next hole. If you are in scanning mode you will need to cancel the scanning pop-up in order to press this button.

Option two: Move the position of the pin to where it is on the hole before you reach the green. Remember, if using this option do not press the ‘PinCollect’ button or it will move the pin to where you are standing

Option 3: Move the position of the pin to where it was after you have completed the hole or at the end of your round.